QUESTION 31
You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:

QUESTION 32
Which type of pipelines collect the gas from the transmission system so utility companies can distribute the gas to end users?

QUESTION 33
You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:

QUESTION 34
The primary purpose of Fireproofing coatings are to provide:

QUESTION 35
NACE International Standards are developed by:

QUESTION 36
You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

QUESTION 37
Ideally, documentation requirements should be defined:

QUESTION 38
Dehumidification is defined as the removal of moisture vapor from the air to

QUESTION 39
You have just your NACE CIP Level 2 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

QUESTION 40
You can use magnifiers to examine all of the following EXCEPT

QUESTION 41
The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

QUESTION 42
NACE No.13/ SSPC 6 identifies the use of:

QUESTION 43
Galvanizing performs best in which of the following exposures:

QUESTION 44
Steel shot grit contaminated with oil or grease used in a cetrifugal blast cleaning should be

QUESTION 45
When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

QUESTION 46
You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:

QUESTION 47
NACE Standards include:

QUESTION 48
When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to:

QUESTION 49
When observing design defects the NACE Inspector should:

QUESTION 50
When environmental enclosures are being used an inspector needs to be concerned about:

QUESTION 51
As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.

QUESTION 52
In which type of concrete are laitance commonly encountered?

QUESTION 53
In the event of a conflict between the Product Data Sheet and the Specification:

QUESTION 54
Coating Surveys are legally required: