NEW QUESTION 17
A single component water borne acrylic coating cures by:

NEW QUESTION 18
Non-Conformance Reports are designed to:

NEW QUESTION 19
When using a destructive Paint Inspection Gauge the NACE inspector must:

NEW QUESTION 20
In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?

NEW QUESTION 21
You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:

NEW QUESTION 22
You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

NEW QUESTION 23
Differences in technique for abrasive blasting concrete versus steel require the operator to:

NEW QUESTION 24
Which type of pipelines collect the gas from the transmission system so utility companies can distribute the gas to end users?

NEW QUESTION 25
On pipelines, which coating is identifiable by its distinct colors, usually light blue, green, or grey?

NEW QUESTION 26
Surface preparation methods for Non-ferrous metals are:

NEW QUESTION 27
Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

NEW QUESTION 28
When observing fabrication defects the NACE Inspector should:

NEW QUESTION 29
The main reason dehumidification is used during coating operations is to

NEW QUESTION 30
When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:

NEW QUESTION 31
You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to: