QUESTION 16
What is the specified performance level for Category 6 cable?

QUESTION 17
You are pre-terminating cable. Where should the labels be placed?

QUESTION 18
Which of the following quantifies the bandwidth of a cabling system in a frequency range of interest?

QUESTION 19
Fall protection is required whenever a person is exposed to a fall hazard more than ____?

QUESTION 20
Which of the following is a floor serving space that serves as a point of termination for horizontal and backbone cables?

QUESTION 21
Which of the following must be measured before the length of a coaxial cable can be calculated?

QUESTION 22
How much sheath of the cable needs to be removed in order to properly terminate an 8P8C?

QUESTION 23
Which type of cabling is installed between a main cross connect and a horizontal cross connect?

QUESTION 24
How much cable slack should be left in the work area after termination?

QUESTION 25
Which of the following topologies is the recommended topology for distribution systems in campus environments?

QUESTION 26
Which of the following components is used to bond the electrical system’s grounding electrode system to the PBB?

QUESTION 27
What type of connector is used with ribbon cable?

QUESTION 28
Which of the following may provide a demarcation point between the service provider and the customer premises cabling?

QUESTION 29
What is the minimum inside bend radius for balanced twisted pair (multi-pair) cable?

QUESTION 30
What is the maximum allowable horizontal cable length?

QUESTION 31
Which topology uses a linear configuration that places all network devices on one length of cable?

QUESTION 32
Which of the following fire ratings refers to the time period that a fire-rated assembly can resist flame passage?

QUESTION 33
What is the maximum permissible amount of untwisting for category 5e cable and higher?

QUESTION 34
Which of the following fire ratings refers to the time period that the unexposed surface of a firestop assembly does not exceed 180 degrees C (325 degrees F) above its initial temperature?

QUESTION 35
Which of the following tend to cause sheath damage during cable pulling?

QUESTION 36
Cavity boxes should be at least _____ away from the wall, where possible.

QUESTION 37
What is the minimum recommended amount of vertical clearance for open-top cable supports?

QUESTION 38
Which of the following is the bonding connection point for telecommunications systems and equipment in the area by a telecommunication space?