Q299. Drag and drop the route verification output from show omp tlocs from the left onto the correct explanations on the right.

Q300. A customer has 1 to 100 service VPNs and wants to restrict outbound updates for VPN1 Which control policy configuration restricts these updates?
A)

B)

C)

D)

Q301. Which VPN connects the transport-side WAN Edge interface to the underlay/WAN network?

Q302. Which two hardware platforms support Cisco IOS XE SD-WAN images” (Choose two)

Q303. Which two best practices should be considered when a customer wants to purchase and implement Voice over Wireless for Cisco 7925 IP Phones? (Choose two.)

Q304. Drag and Drop Question
Drag and drop the code snippets from the bottom onto the boxes in the configuration to create a summary of the 10.0.0.0/16 network specifically for its neighbor router B.
Not all options are used.

Q305. An engineer must automate certificate signing through Cisco.
Which vManage configuration achieves this task?

Q306. A customer is receiving routes via OMP from vSmart controller for a specific VPN. The customer must provide access to the W2 loopback received via OMP to the OSPF neighbor on the service-side VPN, which configuration fulfils these requirements?

Q307. In which device state does the WAN edge router create control connections, but data tunnels are not created?

Q308. Which template configures the out-of-band management VPN?
A)

B)

C)

D)

Q309. Customer has two branch silos with overlapping IPs How must the data policy be configured to establish communication between the sites and server to avoid overlapping?

Q310. When redistribution is configured between OMP and BGP at two Data Center sites that have Direct Connection interlink, which step avoids learning the same routes on WAN Edge routers of the DCs from LAN?

Q311. An engineer is troubleshooting a vEdge router and identifies a “DCONFAIL – DTLS connection failure” message. What is the problem?

Q312. Which component of the Cisco SD-WAN secure extensible network provides a single pane of glass approach to network monitoring and configuration?

Q313. Refer to the exhibit. A route policy with firewall service insertion is created. An engineer is creating a policy where all traffic of VPN1 users at sites 101 and 103 must go through the firewall at site 102. In which direction and for which sites must the policy be applied by the engineer?

Q314. What is the purpose of ”vpn 0” in the configuration template when onboarding a WAN edge node?

Q315. Refer to the exhibit. Which command is needed to prevent end users from sending data traffic through CSR101?

Q316. Which component is responsible for routing protocols such as BGP and OSPF in a Cisco SD-WAN solution?

Q317. An engineer is tasked to improve throughput for connection-oriented traffic by decreasing round-trip latency Which configuration will achieve this goal?

Q318. Refer to the exhibit.

The control connection is failing. Which action resolves the issue?

Q319. Refer to the exhibit.

Customer XYZ cannot provision dual connectivity on both of its routers due to budget constraints but wants to use both R1 and R2 interlaces for users behind them for load balancing toward the hub site. Which configuration achieves this objective?

Q320. Drag and drop the functions from the left onto the correct templates on the right.

Q321. Which attributes are configured to uniquely identify and represent a TLOC route?

Q322.

Refer to the exhibit. A Cisco SD-WAN network carries traffic for several departments and over 1200 users with several applications at site A and site B branches over the MPLS1 circuit. An engineer is provisioning a higher bandwidth on-demand metro circuit as a backup connection. Which two configurations must the engineer apply to implement the on-demand tunnels? (Choose two.)