Updated Sep-2025 Exam Materials for You to Prepare & Pass HPE7-A07 Exam [Q18-Q36]

Rate this post

Updated Sep-2025 Exam Materials for You to Prepare & Pass HPE7-A07 Exam.

Pass Your HPE7-A07 Exam at the First Try with 100% Real Exam

NO.18 An administrator is creating a fabric withNetConductor in HPE Aruba Networking Central Considering an EVPN VXLAN fabric, click on the most appropriate layer to be configured as a Rome-Reflector Persona.

NO.19 Which option shows the correct Banawidth Control for 1024 kbpsdown and 2048 Kops up for the SSID?

NO.20 Exhibit.

Which statement is true?

The SSID supports HR-DSSS data rates

The SSID is supports 6 GHz clients.

The SSID supports 802 11ax clients.

The SSID supports 802 11ac clients.

NO.21 Match each Group Based Policy(GBP) rote description to its respective role ID.

NO.22 You created a new SSID with the security settings shown in the exhibit.

Some, but not all users complain that client devices are unable to connect to this SS1D. What is the reason for this?

The WPA3 Enterprise GCM-2S6 mode does not support transition mode.

WPA3 Enterprise is not backward compatible with WPA2 Enterprise.

MAC authentication after a failed 802. ix authentication is not possible as the option “MAC Authentication Fall-Through” is disabled.

The primary servers shared key differs from the shared key configured for this server on HPE Aruba Networking Central.

NO.23 A customer is running out of IP addresses in a network segment. What will happen If they add an additional IPsubnet to the same VLAN?

Broadcasts for me two subnets win arrive on all ports in the same VLAN

IGMP will not work in both of the subnets in the same VLAN

This would result in a single SVI using two subinterfaces.

Users can reach each other and establish PTP traffic without passing an L3 point in the same VLAN

NO.24 Your customer asked for help to apply an ACL for wireless guest users with the following criteria:
* Wi-Fi guests are on VLAN 555
* allow internet access
* only allow access to public DNS servers
* deny access to all internal networks except for any DHCP server
These session ACLs are already present in the CLI of the mobility gateway group:

You have access to the CLl. Which user role meets all the criteria?

NO.25 You are deploying a new AOS 10 mobility gateway cluster. Due to customer requirements, the gateways must be configured with static IP addresses and are restricted from communicating using port 443 to any URLs except tor “central arubanetworks.com How would you onboard these gateways successfully into HPE Aruba Networking Central?

NO.26 Exhibit.

An engineer has applied the above configuration to R1 and R2 However the routers OSPF adjacency never progresses past the “EXSTART-DR” slate as shown below.

Which configuration action on either router will allow R1 and R2 to progress past the “EXSTART/DR” state?

Change R1 and R2 to a network type of point-to-point.

Remove the layer 3 MTU configuration.

Ensure the OSPF process is not configured with passive-interface default.

Change the IP address and mask applied to interface 1/1/1.

NO.27 Exhibit.

Which statement is true?

The SSID supports RC4 encryption.

The SSID supports 802.11nac clients.

The SSID supports implicit beamforming.

The SSID supports sending neighbor reports.

NO.28 Refer to the CLI output below:

What statement about the output above is correct?

The port-access role was configured with gateway-role visitor

The secondary tunnel endpoint IP is 10.10-10.151.

The client authenticated using dot1x.

The UBT zone was configured to use a user-defined VRF

NO.29 Exhibit.

What is me expected behavior for ARP traffic sent from H1?

A2 will drop the ARP traffic.

A2 will send the ARP traffic out of ports 1/1/1-1/1/4.

A2 willflood the ARP traffic out of all interfaces.

A2 willsend the ARP traffic out of ports 1/1/1 and 1/1/3.

NO.30 Exhibit.

After configuring VRRP between sw-1 and SW-2. you notice that both switches are showing as active. What could be the reason for this issue?

VRRP preemptive mode is disabled.

SW-1 cam reach SW-2 on VLAN 10.

Both switches are configured as VRRP ‘primary.’

SW-2 has no priority configurations for VRRP 1.

NO.31 A customer’s infrastructure is set up to use Doth primary and secondary gateway clusters on the SSID profile What is a valid reason for the AP to failover to the secondary gateway cluster?

The primary gateway cluster is up. out the AP is unable to reach the primary gateway cluster.

The secondary gateway cluster is up. hut the AP is unable to reach the secondary gateway cluster

The secondary gateway cluster is heterogeneous.

The secondary gateway cluster is homogeneous.

NO.32 A customer wan a gateway connected to a device on gigabitethernet0/0/3 configures an Asset ID TLVon the device for inventory management.
Exhibit.

The customer mentions me Asset ID is not shown What is causing the issue?

LLDP TX is not enabled.

LLPD-MED needs to be enabled.

MTU size is too small.

Unknown TLVs cannot be displayed.

NO.33 A customer has recently deployed a wireless system using AP-535S to provide connectivity for their employees who are responsible tor uploading large video files for review. The customer wants to use features that provide throughput gains for large data uploads.
Which feature can be enabled to meet the requirement and simultaneously allow spatially separated clients access to the channel?

Ul-TXBF

OFOMA

DL MU-MIMO

UL MU-MIMO

NO.34 You configured” a bridgedmode SSID with WPA3-Enterprise and EAP-TLS security. When you connect an Active Directory joined client that has valid client certificates. ClearPass shows the following error.

What is needed to resolve this issue?

Enable authorization in your Authentication Method.

Recreate the SSID m tunneled mode.

Modify your ACX-AD authentication source to include the UPN in the search.

Configure ClearPass to trust the client certificate.

NO.35 The ACME company has an AOS-CX 6200 switch stack with an uplink oversubscription ratio of 9.6:1. They are considering adding two more nodes to the stack without adding any additional uplinks due to cabling constraints One oftheir architects has expressed concerns that their critical UDP traffic from both wired and bridged AP clients will encounter packet drops.They have already applied the following configuration:

Which strategy will complement this solution to achieve their objective?

edge mark lower priority TCP traffic with AF12

edge mark critical UDP Traffic with CSS

edge mark lower priority TCP traffic with AF11

edge mark critical UDP traffic with AF42

NO.36 A customer has deployed anAOS 10 mobilitygateway cluster consisting of three controllers at a single site The WLAN is configured to tunnel wireless device traffic to the AOS 10 mobilitycluster.The clients areauthorized to use WPA2-Personal.An end-userhas opened a ticket with the helpdesk stating they cannot connect their client device to the network.There are other devices currently associated with the SSID with no issues.

Reviewing the output, what Is the issue?