Brilliant 300-730 Exam Dumps Get 300-730 Dumps PDF [Q48-Q65]

Rate this post

Brilliant 300-730 Exam Dumps Get 300-730 Dumps PDF

300-730 Dumps PDF – 300-730 Real Exam Questions Answers

Cisco 300-730 certification exam, also known as Implementing Secure Solutions with Virtual Private Networks (SVPN), is designed for network security engineers and administrators who want to validate their knowledge and skills in implementing secure solutions with virtual private networks. Implementing Secure Solutions with Virtual Private Networks certification validates the knowledge and skills required to implement, configure, and troubleshoot secure remote access and site-to-site VPN solutions using Cisco VPN solutions.

Cisco 300-730 certification exam, also known as Implementing Secure Solutions with Virtual Private Networks (SVPN), is designed for IT professionals who want to validate their skills in implementing secure VPN solutions using Cisco technologies. 300-730 exam is part of the Cisco Certified Network Professional (CCNP) Security certification track and is intended for candidates who have already earned the CCNA Security certification or have equivalent experience.

NO.48 Which parameter must match on all routers in a DMVPN Phase 3 cloud?

GRE tunnel key

NHRP network ID

tunnel VRF

EIGRP split-horizon setting

https://journey2theccie.wordpress.com/2020/04/17/dmvpn-phase-3-configuration/ tunnel key is optional

NO.49 Which benefit of FlexVPN is a limitation of DMVPN using IKEv1?

GRE encapsulation allows for forwarding of non-IP traffic.

IKE implementation can install routes in routing table.

NHRP authentication provides enhanced security.

Dynamic routing protocols can be configured.

Section: Secure Communications Architectures

NO.50 Refer to the exhibit.

Which two conclusions should be drawn from the DMVPN phase 2 configuration? (Choose two.)

Next-hop-self is required.

EIGRP neighbor adjacency will fail.

EIGRP is used as the dynamic routing protocol.

EIGRP route redistribution is not allowed.

Spoke-to-spoke communication is allowed.

NO.51 Which technology works with IPsec stateful failover?

GLBR

HSRP

GRE

VRRP

HSRP (Hot Standby Router Protocol). HSRP is a Cisco proprietary protocol that provides stateful failover for IPsec virtual private networks (VPNs). It is used to create a virtual router in order to provide redundancy in the event of an IPsec VPN failure. HSRP works by assigning a single primary router to manage the connection and forwarding traffic to the secondary router if the primary router fails.

NO.52 Refer to the exhibit.

Based on the debug output, which type of mismatch is preventing the VPN from coming up?

interesting traffic

lifetime

preshared key

PFS

The first of the two TS payloads is known as TSi (Traffic Selector- initiator). The second is known as TSr (Traffic Selector-responder). TSi specifies the source address of traffic forwarded from (or the destination address of traffic forwarded to) the initiator of the Child SA pair. https://www.rfc-editor.org/rfc/rfc5996#page-40 If the responder’s policy does not allow it to accept any part of the proposed Traffic Selectors, it responds with a TS_UNACCEPTABLE Notify message.

NO.53 Refer to the exhibit.

The DMVPN tunnel is dropping randomly and no tunnel protection is configured. Which spoke configuration mitigates tunnel drops?

Option A

Option B

Option C

Option D

NO.54 Drag and drop the correct commands from the night onto the blanks within the code on the left to implement a design that allow for dynamic spoke-to-spoke communication. Not all comments are used.

NO.55 Refer to the exhibit.

An SSL client is connecting to an ASA headend. The session fails with the message “Connection attempt has timed out. Please verify Internet connectivity.” Based on how the packet is processed, which phase is causing the failure?

phase 9: rpf-check

phase 5: NAT

phase 4: ACCESS-LIST

phase 3: UN-NAT

NO.56 Under which section must a bookmark or URL list be configured on a Cisco ASA to be available for clientless SSLVPN users?

tunnel-group (general-attributes)

tunnel-group (webvpn-attributes)

webvpn (group-policy)

webvpn (global configuration)

NO.57 Refer to the exhibit.

An IKEv2 site-to-site tunnel between an ASA and a remote peer is not building successfully. What will fix the problem based on the debug output?

Ensure crypto IPsec policy matches on both VPN devices.

Install the correct certificate to validate the peer.

Correct crypto access list on both VPN devices.

Specify the peer IP address in the tunnel group name.

To fix the problem with the IKEv2 site-to-site tunnel between an ASA and a remote peer based on the debug output, you should ensure that the crypto IPsec policy matches on both VPN devices. The debug output indicates that the crypto policies on the two VPN devices are mismatched, which is preventing the tunnel from building successfully. Installing the correct certificate to validate the peer, correcting the crypto access list on both VPN devices, and specifying the peer IP address in the tunnel group name will not fix the problem.

NO.58 In a FlexVPN deployment, the spokes successfully connect to the hub, but spoke-to-spoke tunnels do not form. Which troubleshooting step solves the issue?

Verify the spoke configuration to check if the NHRP redirect is enabled.

Verify that the spoke receives redirect messages and sends resolution requests.

Verify the hub configuration to check if the NHRP shortcut is enabled.

Verify that the tunnel interface is contained within a VRF.

Section: Troubleshooting using ASDM and CLI
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_dmvpn/configuration/15-mt/sec- conn-dmvpn-15-mt-book/sec-conn-dmvpn-summ-maps.pdf

NO.59 Which IKE identity does an IOS/IOS-XE headend expect to receive if an IPsec Cisco AnyConnect client uses default settings?

*$SecureMobilityClient$*

*$AnyConnectClient$*

*$RemoteAccessVpnClient$*

*$DfltlkeldentityS*

Section: Remote access VPNs
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/security/flexvpn/200555-FlexVPN-AnyConnect- IKEv2-Remote-Access.html

NO.60 Refer to the exhibit.

Which type of VPN is being configured, based on the partial configuration snippet?

GET VPN with COOP key server

GET VPN with dual group member

FlexVPN load balancer

FlexVPN backup gateway

NO.61 Refer to the exhibit.

The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which type of mismatch is the problem?

preshared key

peer identity

transform set

ikev2 proposal

NO.62 Refer to the exhibit.

A network engineer is reconfiguring clientless SSLVPN during a maintenance window, and after testing the new configuration, is unable to establish the connection. What must be done to remediate this problem?

Enable client services on the outside interface.

Enable clientless protocol under the group policy.

Enable DTLS under the group policy.

Enable auto sign-on for the user’s IP address.

NO.63 Which two types of web resources or protocols are enabled by default on the Cisco ASA Clientless SSL VPN portal? (Choose two.)

HTTP

ICA (Citrix)

VNC

RDP

CIFS

HTTP (Hypertext Transfer Protocol) is used for transferring web resources, such as web pages and HTML documents, across the internet. CIFS (Common Internet File System) is used for sharing files and printers between computers on a network. ICA (Citrix), VNC (Virtual Network Computing), and RDP (Remote Desktop Protocol) are not enabled by default on the Cisco ASA Clientless SSL VPN portal.
https://www.cisco.com/c/en/us/td/docs/security/asa/asa94/config-guides/cli/vpn/asa-94-vpn-config/webvpn-configure-gateway.html

NO.64 Which VPN solution uses TBAR?

GETVPN

VTI

DMVPN

Cisco AnyConnect

NO.65 In a FlexVPN deployment, the spokes successfully connect to the hub, but spoke-to-spoke tunnels do not form. Which troubleshooting step solves the issue?

Verify the spoke configuration to check if the NHRP redirect is enabled.

Verify that the spoke receives redirect messages and sends resolution requests.

Verify the hub configuration to check if the NHRP shortcut is enabled.

Verify that the tunnel interface is contained within a VRF.

Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_dmvpn/configuration/15-mt/sec-conn- dmvpn-15-mt-book/sec-conn-dmvpn-summ-maps.pdf

Loading …

Valid 300-730 Test Answers & Cisco 300-730 Exam PDF: https://www.surepassexams.com/300-730-exam-bootcamp.html

Leave a Reply Cancel reply