[Dec 31, 2022] Fully Updated Free Actual Cisco 350-501 Exam Questions

Free 350-501 Questions for Cisco 350-501 Exam [Dec-2022]

Introduction to Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies Exam

This exam is for a networking career through how networks operate. This exam introduces architectures, models, protocols, and networking elements – functions needed to support the operations and priorities of mid-sized to large companies and small innovative retailers. You will get the chance to build simple local area networks (LANs) yourself. You will also get a working knowledge of IP addressing schemes, foundational network security, and be able to perform basic configurations for routers and switches.

The primary responsibility of the Associate Network Engineer is to update the technical standards and strategic technical roadmaps. The professionals must take care of the network engineering policies, and operations that include network programmability. The Network Engineer has to act as a backup for the LAN/WAN and Firewall teams whenever required. They must install, monitor, and maintain the LAN infrastructure. The professional should make sure smooth and proper functioning of the network system.

The Troubleshooting and Managing Cisco IP Networks Cisco Training on Demand is an all-inclusive training solution intended to show you how to plan and maintain on a routine basis complex business networks routed and switched. You will first understand how to use technology-based methods and a comprehensive approach to network troubleshooting. You can learn to use both common Cisco IOS troubleshooting tools and more advanced tools such as Syslog, NetFlow, and Cisco IOS Embedded Event Manager (EEM) to help with troubleshooting efforts. In the hands-on workshops, you discover the methods and methods used by network engineers for troubleshooting and managing complex network routed and switching networks. You can also learn how to troubleshoot network connectivity issues, IPv6 connectivity and assignment issues, routing loop issues, Improved Interior Gateway Routing Protocol (EIGRP), Open Shortest Path First (OSPF) Protocol, and Boundary Gateway Protocol (BGP) routing problems. Besides, you are operating via the Dynamic Host Configuration Protocol (DHCP) to resolve problems, network security, and VLAN configuration issues, as well as many other general network issues. A crucial requirement of this course is the opportunity to learn new ideas and deepen comprehension across a wide variety of integrated lab scenarios. You have troubleshooting possibilities through 350-501 practice exam dumps and several lab environments across a variety of case studies.

Exam Details

Cisco 350-501 is a core exam and the applicants will have 120 minutes to cover all the questions of its content. There will be about 90-110 items that can be presented in the following formats: multiple choice, drag and drop, testlets, or fill-in-the-blank. The students are required to gain about 750-850 points for passing this test. Please note that this certification exam is available in English only.

Moreover, the test takers have to be ready to pay the fee of $400. This payment allows them to register and schedule the exam through the Pearson VUE platform that provides them with the opportunity to choose the appropriate delivery option. Thus, if you want to take Cisco 350-501 from the comfort of your office or home, you can opt for online testing. On the other hand, you can choose the in-person variant and have the exam at one of the Cisco testing centers.

NO.137 Refer to the exhibit.

An engineer applied a gRPC dial-in configuration on customer’s router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?

 It is the encoding requested by the gRPC server.

 IT is the encoding that is used for dial-in and dial-out.

 It is used for encoding with the default protocol buffers

 It is the encoding requested by the gRPC client.

NO.138 Refer to the exhibit:

Which command is used to complete this configuration for QoS class-based marking?

 PE-A(config-pmap-c)#set dscp ef

 PE-A(config-pmap-c)#fair-queue

 PE-A(config-pmap-c)#random-detect

 PE-A(config -pmap-c)#priority

NO.139

Refer to the exhibit. When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1.
Which factor should be the reason for this situation?

 LDP needs to be enabled on the R2 loopback interface.

 LDP needs to be enabled on the R2 physical interface.

 R2 does not see any hellos from R1.

 R2 sees the wrong type of hellos from R1.

Section: MPLS and Segment Routing

NO.140 Refer to the exhibit. R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2 R1 message periodically Based on this output, which statement is true?

 IS-IS neighbor authentication is failing for Level 2 first and then for Level 1 PDUs

 1S-1S neighbor authentication is failing for Level 1 and Level 2 PDUs .

 IS-IS neighbor authentication is failing for Level 1 PDUs only

 IS-IS neighbor authentication is failing for Level 2 PDUs only.

NO.141 After a possible security breach, the network administrator of an ISP must verify the times that several different users logged into the network. Which command must the administrator enter to display the login time of each user that activated a session?

 show netconf-yang sessions detail

 show netconf-yang datastores

 show platform software yang-management process

 show netconf-yang sessions

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/167/b_167_programmability_cg/configuring_yang_datamodel.html

NO.142 Refer to the exhibit:

Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

 The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family

 The neighbor relationship is down because R1 believes R2 is in AS 65012.

 The neighbor relationship is up

 The neighbor relationship is down because the loco I-as value for R2 is missing in the R1 neighbor statement

NO.143 Which additional feature does MPLS DiffServ tunneling support?

 matching EXP and DSCP values

 interaction between MPLS and IGP

 using GRE tunnels to hide markings

 PHB layer management

NO.144 Refer to the exhibit. AN engineer is configuring segment routing on an ISP to simplify traffic engineering and management across network domains.
What should the engineer do to complete the implementation of segment routing?

 OSPF must be configured with wide area metrics to support segment routing.

 The segment routing will run without any further configuration.

 Area authentication must be enable before segment routing will run.

 The segment-routing forwarding mpls command is required to install to install SIDs in the forwarding table.

NO.145 Refer to the exhibit:

This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?

 It is used to set up configuration to poll network data

 It is used to enable gRPC

 It is used to create a streaming subscription with a 60-second interval

 It is used to create a streaming subscription with a 600-second interval

NO.146 What is the difference between SNMP and model-driven telemetry?

 Telemetry allows for modeled network data to be pushed to the network administrator on an as-needed basis

 Telemetry uses traps and inform messages to deliver data to a network administrator on a polling basis

 SNMP uses the YANG data modeling language

 SNMP pushes network data to the network administrator whenever it is queried

NO.147 Refer to the exhibit.

An engineer has started to configure a router for OSPF, as shown Which configuration must an engineer apply on the network so that area 15 traffic from R5 to R1 will prefer the route through R4?

 Place the link between R3 and R5 in a stub area to force traffic to use the route through R4.

 Increase the cost on the link between R2 and R4, to influence the path over R3 and R4.

 Implement a multiarea adjacency on the link between R2 and R4, with the cost manipulated to make the path through R4 preferred.

 Implement a sham link on the between R3 and R2 to extend area 0 area 15.

NO.148 You are testing the capabilities of MPLS OAM ping.
Which statement is true?

 MPLS OAM ping works solely with Cisco MPLS TE

 MPLS OAM ping works solely with P2P LSPs

 An LSP breakage results in the ingress MPLS router never receiving any reply

 An LSP is not required for the reply to reach the ingress MPLS router

An MPLS echo reply is sent in response to an MPLS echo request. The reply is sent as an IP packet and it is forwarded using IP, MPLS, or a combination of both types of switching.
Head-end router will receive an echo-reply from the last router (before the broken binding), and that reply will be: ‘U’ – unreachable.

NO.149 Refer to the exhibit. What is significant about the number 2 in the configuration?

 It is the numeric name of the ACL that contains the list of SNMP managers with access to the agent

 It dictates the number of sessions that can be open with the SNMP manager

 It indicates two SNMP managers can read and write with the agent using community string cisco test

 It represents the version of SNMP running

NO.150 Drag and drop the LDP features from the left onto their usages on the right.

NO.151

Refer to the exhibit. Based on the show command output, which result is true after BGP session is established?

 The IOS XR router advertises and accepts all routes to and from eBGP neighbor 192.168.2.2.

 The IOS XR router advertises all routes to the neighbor 192.168.2.2, but it does not accept any routes from
192.168.2.2.

 No routes are accepted from the neighbor 192.168.2.2, nor are any routes advertised to it.

 The IOS XR router does not advertises any routes to the neighbor 192.168.2.2, but it accepts any routes from 192.168.2.2.

Section: Networking

NO.152 Refer to the exhibit:

Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

 The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family

 The neighbor relationship is down because R1 believes R2 is in AS 65012.

 The neighbor relationship is up

 The neighbor relationship is down because the loco I-as value for R2 is missing in the R1 neighbor statement

NO.153 An engineer Is implementing NSR with OSPF on a large campus that requires high availability.
Which task must an engineer perform to complete the process with minimal disruption to traffic?

 Reset OSPF neighbour sessions to maintain state Information during router switchover

 Configure the device to repopulate state information using routing updates received from the BDR

 increase the keepalive interval on the OSPF neighbours so that traffic continues to pass during the switchover.

 Ensure that the dual HP has synchronized their state information before performing the switchover operation.

NO.154 Which configuration modifies Local Packet Transport Services hardware policies?
A)

B)

C)

D)

 Option A

 Option B

 Option C

 Option D

NO.155 Drag and Drop Question
Drag and drop the characteristics from the left onto the corresponding radio splitting approaches on the right.

NO.156 Refer to the exhibit:

If router A is the RP, which PIM mode can you configure so that devices will send multicast traffic toward the RP?

 PIM-SM

 PI MM-DM

 BIDIR-PIM

 PIM-SSM

NO.157 Refer to the exhibit.

A network engineer with an employee id: 3812:12:993 has started to configure router R1 for IS-IS as shown.
Which additional configuration must be applied to configure the IS-IS instance to advertise only network prefixes associated to passive interfaces?

 Option A

 Option B

 Option C

 Option D

NO.158 A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements:
– Management protocols must be marked with DSCP AF class 2 w4h low drop probability.
– Monitoring protocols must be marked with DSCP AF class 1 with low
drop probability.
– All remaining traffic must be marked with a DSCP value of 0.
Which configuration must the engineer implement to satisfy the requirements?

 

 

 

 

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/sw/4_0/qos/configuration/ guide/nexus1000v_qos/qos_6dscp_val.pdf

 Loading …

Cisco SPCOR 350-501 Practice Test Questions, Cisco SPCOR 350-501 Exam Practice Test Questions

The Cisco 350-501 exam is all about the implementation and operation of Cisco service provider network technologies. This test is part of the requirements for the CCNP Service Provider and CCIE Service Provider certifications. If you want to get the professional-level option, you will need to pass one of the three concentration exams. If you pursue the expert-level certificate, you will have to deal with the lab test after completing the core one. Otherwise, if you are not ready for any of the second exams to clear, you will obtain the specialist-level certification in the Service Provider Core domain.

Validate your 350-501 Exam Preparation with 350-501 Practice Test: https://www.surepassexams.com/350-501-exam-bootcamp.html

         

Related Links: myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt disqus.com